NEC Univerge SV8100 Programming Manual - page 417
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 377
Default
Item 01 : Internal Paging Group Name
#
#
= Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing
#
again = Space. (In system
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Conf
Clear the character entry one character at a time.
Hold
Clear all the entries from the point of the flashing cursor and to the
right.
Input Data
Internal Paging Group Number
01~64
Item
No.
Item
Input Data
Default
01
Internal Paging Group Name
Assign name to Internal Paging Groups (i.e., Page
Zones). The system shows the name you program on the
telephone display.
Up to 12 Characters
Refer to
default
table.
Extension
Paging Group
Name
01
Group 1
02
Group 2
:
:
64
Group 64
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to
12 digits.
Use this keypad
digit . . .
When you want to. . .