NEC Univerge SV8100 Programming Manual - page 343
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 303
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
Enter characters:
+ , - . / : ; < = >
?
B
E
σ
S
∞
¢ £
#
# = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing # again = Space.
(In system programming mode, use the right arrow soft key
instead to accept and/or add a space.)
CONF
Clear the character entry one character at a time.
HOLD
Clear all the entries from the point of the flashing cursor and to the
right.
Input Data
Conversion Table Number
1~2000
Item
No.
Item
Input Data
Default
01
Received Number
This is the received DID digits.
Maximum 8 digits
No Setting
02
Target Number
Enter the destination number to which the
DID number is sent.
Maximum 24 digits
No Setting
03
DID Name
This is the name that is assigned to the
DID digits when it rings the extension.
Maximum 12 characters
No Setting
04
Transfer Operation Mode
0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
0
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit . . .
When you want to. . .