NEC Univerge SV8100 Programming Manual - page 31
UNIVERGE SV8100
Issue 1.0
Programming Manual
1 - 3
S
ECTION
4
H
OW
TO
E
XIT
P
ROGRAMMING
M
ODE
To exit the programming mode:
When you are done programming, you must be out of a program option to exit
(pressing the Answer key will exit the program option).
1.
Press Answer key to exit the program options, if needed.
2.
Press Speaker. If changes were to the system programming, "Saving System
Data" is displayed.
3.
The display shows "Complete Data Save" when completed and exits the
telephone to an idle mode.
To save a customer’s database, a blank USB Drive is required. Insert the USB Drive into
the CD-CP00-US and, using Program 90-03, save the software to the USB Drive.
(Program 90-04 is used to reload the customer data if necessary.) Note that a USB Drive
can only hold one customer database. Each database to be saved requires a separate
drive.
Password
User
Name
Level
Programs at this Level
47544
necii
1 (MF)
Manufacturer (MF):
All programs
12345678
tech
2 (IN)
Installation (IN):
All programs in this section not listed below for SA and
SB
0000
ADMIN1
3 (SA)
System Administrator – Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17,
10-18, 10-22, 12-02, 12-03, 12-04, 15-01, 15-07, 15-09,
15-10, 15-11, 20-16, 21-07, 21-14, 22-04, 22-11, 25-08,
30-03, 32-02, 40-02, 41-02, 41-03, 41-04, 41-05, 41-06,
41-07, 41-08, 41-09, 41-10, 41-11, 41-12, 41-13, 41-14,
41-15, 41-16, 41-17, 41-18, 90-03, 90-04, 90-06, 90-07,
90-18, 90-19
9999
ADMIN2
4 (SB)
System Administrator – Level 2 (SB):
13-04, 13-05, 13-06
Program Mode
Base Service OP1 OP2