NEC Univerge SV8100 Programming Manual - page 196
Issue 1.0
UNIVERGE SV8100
2 - 156
Program 15 : Extension, Basic Setup
03
Extension Ring Tone
Use this option to set the tone
(pitch) of the incoming extension
call ring for the extension port you
are programming. Also refer to
Program 15-08.
DTU/DTP style telephones only
follow high, medium and low
range ring tone settings. They do
not follow Melodies.
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
8
04
Redial (Speed Dial) Control
Use this option to control the
function of the extension Redial
key when used with Speed Dialing.
The Redial key can access either
the Common or Group Speed
Dialing numbers.
0 = Common and Individual
Speed Dialing
1 = Group Speed Dialing
0
05
Transfer Key Operation Mode
Use this option to set the operating
mode of the extension CONF key.
The keys can be for Call Transfer,
Serial Calling or Flash. When
selecting the Flash option
(selection 2), refer also to Program
81-01-14.
0 = Transfer
1 = Call back
2 = Hook
0
06
Hold Key Operating Mode
Use this option to set the function
of the Multiline Hold key. The Hold
key can activate normal Hold or
Exclusive Hold.
0 = Normal (Common)
1 = Exclusive Hold
0
07
Automatic Hold for CO Lines
When talking on a CO call and
another CO line key is pressed, the
original trunk is placed on Hold (0)
or Disconnected (1).
0 = Hold
1 = Disconnect (Cut)
1
08
Automatic Handsfree
Use this option to set whether
pressing a key accesses a
One-Touch Key or if it preselects
the key.
0 = Preselect
1 = One-Touch (Automatic
Handsfree)
1
10
Ringing Line Preference for
Trunk Calls
Use this option to select between
Idle and Ringing Line Preference
for trunk calls.
0 = Idle (Off)
1 = Ringing (On)
1
Item
No.
Item
Input Data
Default
Related
Program