NEC Univerge SV8100 Programming Manual - page 301
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 261
12
Dial E911 Routing Without Trunk
Access
If enabled (1), an extension user can
dial 911 (USA only) without first
dialing a trunk access code or
pressing a line key. If disabled (0), an
extension user must dial a trunk
access code (e.g., 9) or press a line
key before dialing 911 (USA only).
0 = Trunk
Access
Code
Required
1 = Trunk
Access
Code Not
Required
1
13
Alarm Ring Timer (E911)
Use this option to set the duration of
the E911 Alarm Ring Time. If set for 0,
the E911 Alarm does not ring.
0, 1~64800 (sec)
(0 = Off)
0
11-12-56
20-08-16
14
Forced Account Code Inter-digit
Timer
The system waits this time for a user
to enter a Forced Account code.
0~64800
(sec)
3
15
Outgoing Disable on Incoming Line
(Toll Restriction)
Enable or disable the Outgoing
Disable on Incoming Line feature.
0 = Disable
(Off)
1 = Enable (On)
0
15-01-05
21-01-16
21-01-17
16
Supervise Dial Detection Timer
With the Outgoing Disable on
Incoming Line feature, if dial tone is
not detected after the extension
answers an incoming line, the system
determines the call is unable to
complete and releases the DTMF
receiver.
0~64800 (sec)
20
15-01-05
21-01-16
21-01-17
17
Restriction Digit in Outgoing
Disable on Incoming Line
With the Outgoing Disable on
Incoming Line feature, determine the
number of digits to be dialed before
the call should be disconnected.
Digits 0~9
4
15-01-05
21-01-15
21-01-16
18
Reset Dial After Failure of Trunk
Access
Enable (1) or Disable (0) the ability to
continue to dial codes or extensions
after receiving Trunk Busy. This
needs to be set to Enabled (1) for the
Forced Trunk Disconnect feature to
work.
0 = Disable
(Off)
1 = Enable (On)
1
99-01-01
19
--- Not Used ---
Input Data
Item
No.
Item
Input Data
Default
Related
Program