NEC Univerge SV8100 Programming Manual - page 49
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 9
For BRIA PKG Setup
ISDN Line Number
01~04
Item
No
Item
Input Data
Default
01
ISDN Line Mode
0 = Not Used
1 = T-Point
1
02
Logical Port Number
The starting port number of a BRI
line is displayed. Two logic ports are
automatically assigned to a BRI line.
0 = Not Used
1 = For T-Bus (1~200)
0
03
Connection Type
0 = Point-to-Multipoint
1 = Point-to-Point
0
04
Layer 3 Timer Type
Each timer value of Layer 3 is set up
for every type using Program 81-06
(T-Bus).
1~5
1
05
CLIP Information Announcement
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
0 = Disable
1 = Enable
1
06
--- Not Used ---
07
--- Not Used ---
08
Dial Sending Mode
ISDN Protocol definition
0 = Enblock Sending
1 = Overlap Sending
1
09
Dial Information Element
ISDN Protocol definition
[Only when Dialing Sending Mode
(10-03-08) is set for 1 (Overlap Sending]
0 = Keypad Facility
1 = Called Party Number
0
10
Master/Slave System
If set to 0, system is synchronized to
network clock. If set to 1, system is not
synchronized to the network clock.
0 = Slave System
1 = Master System
0
11
--- Not Used ---
14
--- Not Used ---
15
--- Not Used ---
17
ISDN Line Ringback Tone
If Telco does not provide ringback tone,
SV8100 can if set to 1:Enable.
0 = Disable
1 = Enable
0