NEC Univerge SV8100 Programming Manual - Program 34 : Tie Line Setup
Other manuals for Univerge SV8100:
Service Information Bulletin, Description, User Manual, User Manual, Quick Start User Manual, User Manual, Information Sheet, User Manual, System Specifications, Configuration Manual, User Manual, User Manual, Quick Reference Manual, Quick Reference Manual, Programming Manual, General Description Manual, User Manual, System Maintenance Manual, User Manual, Features And Specifications Manual, Quick Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, User Manual, Installation Manual, Installation Manual, Reference Manual, User Manual, System Hardware Manual, Reference sheet, Reference Sheet, Quick Start & Reference Manual, System Configuration Manual, User Manual, User Manual, Administrator's Manual, User Manual, Quick Reference Manual, Quick Reference Manual, User Manual, User Manual, System Hardware Manual, Installation Manual, Condensed User's Manual, Installation Manual, Quick Reference Manual, System Hardware Manual, User Manual, Installation Manual, Administration Manual, Quick Reference Manual, System Hardware Manual, Features & Specifications Manual, Adminstrators Manual, System Hardware Manual, Programming Manual, Applications, System Hardware Manual, User Manual, Installation Manual, Reference Sheet
of
812
Issue 1.0
UNIVERGE SV8100
2 - 396
Program 34 : Tie Line Setup
Description
Use Program 34-05 : Tie Line Outgoing Call Restriction to build a restriction matrix
for outgoing trunk calls placed from an inbound trunk (e.g., dialed from a Tie Line).
For each inbound trunk group, enable or disable access to each CO trunk group.
Conditions
None
Feature Cross Reference
Tie Lines
Program 34 : Tie Line Setup
34-05 : Tie Line Outgoing Call Restriction
Level:
IN
Input Data
Incoming Trunk Group Number
001~100
Outgoing Trunk
Group Number
Input Data
Default
1~100
0 = Enable (Y-Tandem)
1 = Disable (N-Tandem)
0