NEC Univerge SV8100 Programming Manual - page 512
Other manuals for Univerge SV8100:
Service Information Bulletin, Description, User Manual, User Manual, Quick Start User Manual, User Manual, Information Sheet, User Manual, System Specifications, Configuration Manual, User Manual, User Manual, Quick Reference Manual, Quick Reference Manual, Programming Manual, General Description Manual, User Manual, System Maintenance Manual, User Manual, Features And Specifications Manual, Quick Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, Features And Specifications Manual, User Manual, Installation Manual, Installation Manual, Reference Manual, User Manual, System Hardware Manual, Reference sheet, Reference Sheet, Quick Start & Reference Manual, System Configuration Manual, User Manual, User Manual, Administrator's Manual, User Manual, Quick Reference Manual, Quick Reference Manual, User Manual, User Manual, System Hardware Manual, Installation Manual, Condensed User's Manual, Installation Manual, Quick Reference Manual, System Hardware Manual, User Manual, Installation Manual, Administration Manual, Quick Reference Manual, System Hardware Manual, Features & Specifications Manual, Adminstrators Manual, System Hardware Manual, Programming Manual, Applications, System Hardware Manual, User Manual, Installation Manual, Reference Sheet
of
812
Issue 1.0
UNIVERGE SV8100
2 - 472
Program 44 : ARS/F-Route Setup
Conditions
None
Feature Cross Reference
Automatic Route Selection (ARS)
08
Dial Treatment
Select the Dial Treatment to be used for the table. If
a Dial Treatment is selected, Programs 44-05-02
and 44-05-03 are ignored and the Dial Treatment
defined in Program 26-03-01 is used instead.
0~15
0
09
Maximum Digit
Input the maximum number of digits to send when
using the F-Route.
0~24
0
10
CCIS over IP Destination Point Code
Input the Destination Point Code to send when using
this F-Route.
0~16367
0
11
Network Specified Parameter Table
Enter a table number from Program 26-12.
0~16
0
Item
No.
Item
Input Data
Default