NEC Univerge SV8100 Programming Manual - page 85
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 45
Description
Use Program 10-29 : SIP Server Information Setup to define the SIP Proxy setup
for outbound/inbound. The 10-29 commands are not used in non-registration mode.
If entries are made in Program 10-29-xx for a SIP Server and the SIP Server is then removed or
not used, the entries in Program 10-29-xx must be set back to their default settings. Even if
10-29-01 is set to 0 (off), the SV8100 still checks the settings in the remaining 10-29 programs.
Program 10 : System Configuration Setup
10-29 : SIP Server Information Setup
Level:
IN
Input Data
Item
No.
Item
Input Data
Default
01
Default Proxy
(Outbound)
This sets whether
the SIP message is
always sent through
the Default Proxy.
0 = Off
1 = On
0
02
Default Proxy
(Inbound)
Need to be
registered in
registration mode.
This sets whether
the SIP message is
always received
through the Default
Proxy.
0 = Off
1 = On
0
03
Default Proxy IP
Address
This is optional and
used if the provider
gives you a proxy
address that is
different than the
registration address.
If the provider is
using domain names
instead of IP
addresses, leave
this at default.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0