NEC Univerge SV8100 Programming Manual - page 307
UNIVERGE SV8100
Issue 1.0
Programming Manual
2 - 267
08
Restriction Table
1~4 = Table
0 = Disable
(None)
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
Set the tables 1~4 when referring
to the table set up by 21-06-07.
21-06-07
09
Restriction for
Common Speed Dials
0 = Does Not
Restrict
1 = Following
Restriction
Check
0
Use this option to enable/disable
Toll Restriction for Common
Speed Dialing numbers. If
enabled, System Speed Dialing
numbers have the same
restrictions as manually dialed
numbers.
10
Restriction for Group
Speed Dials
0 = Does Not
Restrict
1 = Following
Restriction
Check
0
Use this option to enable/disable
Toll Restriction for Group Speed
Dialing numbers. If enabled,
Group Speed Dialing numbers
have the same restrictions as
manually dialed numbers.
11
Intercom Call
Restriction
0 = Disable
(No)
1 = Enable
(Yes)
0
Determines if incoming and
outgoing intercom calls are
allowed.
12
PBX Call Restriction
0 = Disable
(No)
1 = Enable
(Yes)
1~6, 8~15 = 0
7 = 1
Use this option to set how the
system Toll Restricts calls over
PBX trunks. If you enable PBX
Toll Restriction, the system begins
Toll Restriction after the PBX
access code. The user cannot dial
a PBX extension. If you disable
PBX Toll Restriction, the system
only restricts calls that contain the
PBX access code. The system
does not restrict calls to PBX
extensions. Refer to the PBX
compatibility feature. Make sure
Program 21-05-04 (Maximum
Number of Digits Table
Assignment) allows for PBX Toll
Call Dialing (normally 12 digits).
13
Restriction of Tie
Line Calls
0 = Disable
(No)
1 = Enable
(Yes)
0
It chooses whether the toll
restriction of the dial set up by
34-08 is enabled or disabled.
34-08
14
Trunk Transfer
Restriction on
Incomplete Dial
0 = Not allow
1 = Allow
0 (Not allow)
If this program is set to 1, you can
transfer the outgoing trunk which
you dialed incompletely.
15
Common Hold
Restriction on
Incomplete Dial
0 = Not allow
1 = Allow
0 (Not allow)
If this program is set to 1, you can
hold the outgoing trunk which you
dialed in restriction check.
Item
No.
Item
Input Data
Default
Description
Related
Program