Jeep Cherokee 2000 Service Manual - page 1066
(5) Remove the engine support.
(6) Lower the vehicle.
(7) Connect negative cable to battery.
ENGINE MOUNT—REAR
A resilient rubber cushion supports the transmis-
sion at the rear between the transmission extension
housing and the rear support crossmember or skid
plate.
REMOVAL
(1) Disconnect negative cable from battery.
(2) Raise the vehicle and support the transmission.
(3) Remove the nuts holding the support cushion
to the crossmember (Fig. 46) (Fig. 47). Remove the
crossmember.
MANUAL TRANSMISSION
(Fig. 46)
a. Remove the support cushion nuts and remove
the cushion.
b. Remove the transmission support bracket bolts
and remove the bracket from the transmission.
AUTOMATIC TRANSMISSION
(Fig. 47)
a. Remove the support cushion bolts and remove
the cushion and the support bracket from the trans-
mission (4WD) or from the adaptor bracket (2WD).
b. On 2WD vehicles, remove the bolts holding the
transmission support adaptor bracket to the trans-
mission (Fig. 47). Remove the adaptor bracket.
INSTALLATION
MANUAL TRANSMISSION:
a. Install the transmission support bracket to the
transmission. Install the bolts and tighten to 46 N·m
(34 ft. lbs.) torque.
Fig. 44 Front Mounts
1 – ENGINE SUPPORT BRACKET
2 – THROUGH BOLT
3 – SUPPORT CUSHION
4 – SUPPORT CUSHION BRACKET
5 – ENGINE SUPPORT BRACKET
6 – THROUGH BOLT
7 – SUPPORT CUSHION BRACKET
8 – SUPPORT CUSHION
Fig. 45 Support Cushion Bracket
1 – SUPPORT CUSHION BRACKET
2 – SUPPORT CUSHION BRACKET
XJ
4.0L ENGINE
9 - 91
REMOVAL AND INSTALLATION (Continued)