Jeep Cherokee 2000 Service Manual - page 1763
INSTALLATION
(1) Position the weatherstrip on the door.
(2) Push weatherstrip down to seat onto door.
(3) Install door trim panel.
FRONT DOOR OUTER BELT WEATHERSTRIP
REMOVAL
(1) Roll window down.
(2) Using a trim stick, pry up the rear outer corner
of the weatherstrip.
(3) Lift the weatherstrip up to separate from the
door (Fig. 32).
INSTALLATION
(1) Position the weatherstrip on the door.
(2) Push weatherstrip down to seat onto door.
FRONT DOOR GLASS RUN CHANNEL
WEATHERSTRIP
REMOVAL
(1) Remove door trim panel.
(2) Remove waterdam.
(3) Starting at rear corner, peel weatherstrip from
around door frame.
INSTALLATION
(1) Install
the
weatherstrip
in
the
following
sequence:
•
Press weatherstrip into upper rear corner.
•
Press weatherstrip into lower front corner.
•
Work/press the weatherstrip upward and to the
upper front corner, seat the weatherstrip into the
channel.
•
Continue working/pressing the weatherstrip into
the channel along the upper window frame.
•
Press weatherstrip into lower rear corner.
•
Work/press the weatherstrip upward and to the
upper rear corner, seat the weatherstrip into the
channel.
•
Press the weatherstrip to seat into the front
lower glass run channel.
(2) As
applicable,
move
upward
and
forward
evenly until the weatherstrip seal is fully seated in
the channel.
(3) Install waterdam.
(4) Install door trim panel.
FRONT DOOR OPENING WEATHERSTRIP
REMOVAL
(1) Remove A-pillar trim panel.
(2) Remove B-pillar upper trim panel.
(3) Remove cowl side trim panel.
(4) Remove inner scuff plate.
(5) Remove B-pillar lower trim panel.
(6) Grasp seal and separate from door opening.
Fig. 32 Front Door Inner/Outer Belt Weatherstrip
1 – OUTER BELT WEATHERSTRIP
2 – INNER BELT WEATHERSTRIP
3 – DOOR INNER PANEL
Fig. 33 Door Opening Weatherstrip
1 – FRONT DOOR SEAL
2 – A PILLAR
3 – SECONDARY DOOR SEAL
4 – FRONT DOOR SEAL
5 – REAR DOOR SEAL
6 – ENDS MEET AT CENTERLINE
7 – A PILLAR
23 - 38
BODY
XJ
REMOVAL AND INSTALLATION (Continued)