Jeep Cherokee 2000 Service Manual - page 1766
FRONT DOOR SPACER BLOCKS—TWO-DOOR
VEHICLES
REMOVAL
(1) Upper spacer block: drill-out the rivet heads
and remove them from the reinforcement plate (Fig.
39).
(2) Lower spacer block: remove the screws from
the door face (Fig. 40).
(3) As applicable, remove the spacer block from the
door window frame or door face.
INSTALLATION
(1) As applicable, position the spacer block on the
door window frame or door face.
(2) Upper spacer block: Install the replacement
rivets in the spacer block and reinforcement plate.
(3) Lower spacer block: install the screws in the
door face. Tighten the screws to 1 N·m (11 in-lbs)
torque.
FRONT DOOR GLASS
REMOVAL
(1) Remove the door trim panel.
(2) Remove the waterdam.
(3) Remove inner and outer belt weatherstrip.
(4) Roll glass up to expose the bolts attaching the
glass to the regulator.
(5) Remove the bolts attaching the glass to the
regulator (Fig. 41).
(6) Lift the glass upward and out of the door.
INSTALLATION
(1) Position the glass in the door.
(2) Install the bolts attaching the glass to the reg-
ulator Tighten the bolts to 4 N·m (36 in-lbs) torque.
(3) Install inner and outer belt weatherstrip.
Fig. 39 Front Door Upper Spacer Block—Two-Door
1 – FRONT DOOR WINDOW FRAME
2 – RIVET
3 – WINDOW OUTER FRAME
4 – WINDOW INNER FRAME
5 – WINDOW GLASS
6 – REINFORCEMENT PLATE
7 – RIVET
8 – DOOR UPPER SPACER BLOCK
9 – WINDOW OUTER FRAME
10 – REINFORCEMENT PLATE
11 – DOOR UPPER SPACER BLOCK
12 – WINDOW INNER FRAME
13 – RIVET
14 – ADHESIVE
Fig. 40 Front Door Lower Spacer Block—Two-Door
1 – DOOR SPACER
2 – DOOR FACE
3 – DOOR FACE
4 – DOOR SPACER
5 – SCREW
6 – SCREW
Fig. 41 Front Door Glass
1 – NUT
2 – RETAINER
3 – WINDOW GLASS
4 – REGULATOR
XJ
BODY
23 - 41
REMOVAL AND INSTALLATION (Continued)