Jeep Cherokee 2000 Service Manual - page 566
(5) Lower the overhead console far enough to
access the two wire harness connectors.
(6) Unplug one wire harness connector near the
push button module towards the front of the over-
head console.
(7) Unplug one wire harness connector from the
Remote Keyless Entry (RKE) receiver near the center
of the overhead console, if the vehicle is so equipped.
(8) Remove the overhead console from the head-
liner.
(9) Reverse the removal procedures to install.
Tighten the overhead console mounting screws to 2.7
N·m (24 in. lbs.).
TRIP COMPUTER, COMPASS, AND
THERMOMETER DISPLAY MODULE
(1) Remove the overhead console from the vehicle.
See Overhead Console in this group for the proce-
dures.
(2) Remove the two screws that secure the forward
end of the trip computer, compass, and thermometer
display module to the overhead console housing (Fig.
4).
(3) Gently flex the sides of the overhead console
housing as required to release the trip computer,
compass, and thermometer display module mounting
pins.
(4) Pull the trip computer, compass, and thermom-
eter display module away from the overhead console
housing far enough to access the two wire harness
connectors.
(5) Unplug the overhead console and push button
module wire harness connectors from the trip com-
puter, compass, and thermometer display module.
(6) Remove the trip computer, compass, and ther-
mometer display module from the overhead console
housing.
(7) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
PUSH BUTTON MODULE
(1) Remove the overhead console from the vehicle.
See Overhead Console in this group for the proce-
dures.
(2) Unplug the push button module wire harness
connector from the trip computer, compass, and ther-
mometer display module.
(3) Remove the four screws that secure the push
button module to the overhead console housing (Fig.
5).
(4) Remove the push button module from the over-
head console.
(5) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
Fig. 3 Overhead Console Remove/Install
1 – HEADLINER
2 – REAR BRACKET
3 – REAR MOUNTING TAB
4 – OVERHEAD CONSOLE
5 – SCREW
6 – SCREW
Fig. 4 Trip Computer, Compass, and Thermometer
Display Module Remove/Install
1 – TRIP COMPUTER, COMPASS AND THERMOMETER
DISPLAY MODULE
2 – OVERHEAD CONSOLE HOUSING
3 – PUSH BUTTON MODULE CONNECTOR
4 – OVERHEAD CONSOLE WIRE HARNESS CONNECTOR
5 – MOUNTING SCREWS
6 – MOUNTING PINS
XJ
OVERHEAD CONSOLE SYSTEMS
8V - 7
REMOVAL AND INSTALLATION (Continued)