Jeep Cherokee 2000 Service Manual - page 153
(3) Install a new axle seal with Installer C-4076-B
and Handle C-4735-1. When the tool contacts the
axle tube, the seal is installed to the correct depth.
(4) Coat the lip of the seal with axle lubricant for
protection prior to installing the axle shaft.
(5) Install the axle shaft.
PINION SEAL
REMOVAL
(1) Raise and support the vehicle.
(2) Scribe a mark on the universal joint, pinion
yoke, and pinion shaft for reference.
(3) Disconnect the propeller shaft from the pinion
yoke. Secure the propeller shaft in an upright posi-
tion to prevent damage to the rear universal joint.
(4) Remove the wheel and tire assemblies.
(5) Remove the brake drums to prevent any drag.
The drag may cause a false bearing preload torque
measurement.
(6) Rotate the pinion yoke three or four times.
(7) Measure the amount of torque necessary to
rotate the pinion gear with a (in. lbs.) dial-type
torque wrench. Record the torque reading for instal-
lation reference.
(8) Hold the yoke with Wrench 6719. Remove the
pinion nut and washer.
(9) Remove the yoke with Remover C-452 (Fig. 13).
(10) Remove the pinion seal with suitable pry tool
or slide-hammer mounted screw.
INSTALLATION
(1) Clean the seal contact surface in the housing
bore.
(2) Examine the splines on the pinion shaft for
burrs or wear. Remove any burrs and clean the shaft.
(3) Inspect pinion yoke for cracks, worn splines
and worn seal contact surface. Replace yoke if neces-
sary.
NOTE: The outer perimeter of the seal is pre-coated
with a special sealant. An additional application of
sealant is not required.
(4) Apply a light coating of gear lubricant on the
lip of pinion seal.
(5) Install the new pinion seal with Installer
C-4076-B and Handle C-4735-1 (Fig. 14).
NOTE: The seal is correctly installed when the seal
flange contacts the face of the differential housing
flange.
Fig. 12 Axle Shaft Seal and Bearing Installation
1 – HANDLE
2 – INSTALLER
3 – AXLE TUBE
Fig. 13 Yoke Removal
1 – PINION YOKE
2 – TOOL C452
Fig. 14 8 1/4 Axle Pinion Seal Installation
1 – SPECIAL TOOL C-4735
2 – DIFFERENTIAL HOUSING
3 – SPECIAL TOOL C-4076-A
XJ
8 1/4 REAR AXLE
3 - 113
REMOVAL AND INSTALLATION (Continued)