Jeep Cherokee 2000 Service Manual - page 1458
(18) Position transfer plate on bench so separator
plate, and filter are facing up. This will avoid having
rear clutch and rear servo check balls fall out when
plates are separated.
(19) Remove screws attaching separator plate to
transfer plate (Fig. 103).
(20) Note position of filter, rear clutch servo and
rear servo check balls for assembly reference (Fig.
103) and (Fig. 104).
(21) Remove shuttle valve end plate (Fig. 105).
(22) Remove shuttle valve E-clip and remove sec-
ondary spring and spring guides from end of valve
(Fig. 106).
Fig. 100 Clutch Module And Connecting Tube
1 – MODULE AND CONNECTING TUBE
Fig. 98 Park Rod
1 – MANUAL LEVER
2 – E-CLIP
3 – PARK ROD
Fig. 99 Converter Clutch Solenoid
1 – VALVE BODY
2 – TORQUE CONVERTER CLUTCH SOLENOID
Fig. 101 Converter Clutch and Fail Safe Valves
1 – COVER PLATE
2 – CONVERTER CLUTCH VALVE
3 – TORQUE CONVERTER CLUTCH MODULE
4 – MODULE CONNECTING TUBE
5 – FAIL-SAFE VALVE
Fig. 102 Valve Body Transfer Plate Screws
1 – TRANSFER PLATE
2 – VALVE BODY
3 – SEPARATOR PLATE
21 - 158
AUTOMATIC TRANSMISSION—30RH
XJ
DISASSEMBLY AND ASSEMBLY (Continued)