Jeep Cherokee 2000 Service Manual - page 1562
(5) Remove and discard adapter O–ring.
INSTALLATION
(1) Lubricate new O–ring and install it on adapter.
(2) Install solenoid wire harness and adapter in
case.
(3) Install adapter bracket and bracket bolt.
(4) Connect wires to solenoids.
(5) Install oil screen.
(6) Apply bead of Threeebond
t
Liquid Gasket
TB1281, P/N 83504038, to oil pan seal surface.
Sealer bead should be at least 3 mm (1/8 in.) wide.
(7) Install oil pan on transmission. Tighten pan
bolts to 7 N·m (65 in. lbs.) torque.
(8) Install and tighten oil pan drain plug to 20
N·m (15 ft. lbs.) torque.
(9) Fill transmission with Mopar Dexron IIE/Mer-
con.
MANUAL VALVE SHAFT SEAL
REMOVAL
(1) Remove park/neutral position switch and dis-
connect transmission shift lever (Fig. 74).
(2) Remove oil pan and valve body.
(3) Remove bolts attaching park rod bracket to
case (Fig. 75).
(4) Remove park rod from shift sector (Fig. 76).
(5) Cut spacer sleeve with chisel and remove it
from manual valve shaft (Fig. 77).
(6) Remove pin from shaft and sector with pin
punch.
(7) Remove shaft and sector from case.
Fig. 74 Manual Valve Shaft And Seals
1 – SHAFT SEAL
2 – PIN
3 – MANUAL VALVE SHAFT
4 – SHAFT SEAL
5 – SPACER SLEEVE
6 – SHIFT SECTOR
Fig. 75 Removing/Installing Park Rod Bracket
1 – PARK ROD
2 – PARK ROD BRACKET
Fig. 76 Removing/Installing Park Rod
1 – SHIFT SECTOR
2 – MANUAL VALVE SHAFT
3 – PARK ROD
21 - 262
AW–4 AUTOMATIC TRANSMISSION
XJ
REMOVAL AND INSTALLATION (Continued)