Jeep Cherokee 2000 Service Manual - page 555
from the inner door to release the trim panel
retainer.
(12) Unplug the power mirror wire harness con-
nector.
(13) Remove the three screws that secure the
power mirror to the inner door panel (Fig. 11).
(14) Unseat the power mirror wire harness grom-
met by pushing it out through the hole in the door
flag from the inside.
(15) Pull the mirror and seal from the outside of
the door while feeding the wire harness, grommet,
and connector out through the hole from the inside of
the door.
(16) Reverse the removal procedures to install.
Tighten the mirror mounting screws to 4.3 N·m (38
in. lbs.). Tighten the door trim mounting screws to
2.2 N·m (20 in. lbs.).
Fig. 10 Front Door Flag Trim Panel Remove/Install
1 – FRONT DOOR
2 – DOOR FLAG TRIM PANEL
3 – RETAINER
4 – SCREW
5 – UPPER SPEAKER WIRE HARNESS
Fig. 11 Power Mirror Remove/Install
1 – SIDE VIEW MIRROR
2 – WIRE HARNESS
3 – SEAL
4 – GROMMET
5 – DOOR
8T - 6
POWER MIRROR SYSTEMS
XJ
REMOVAL AND INSTALLATION (Continued)