Jeep Cherokee 2000 Service Manual - page 527
To program the Remote Keyless Entry (RKE)
receiver so that the horn chirp feature is disabled,
proceed as follows:
(1) While within the reception range of the RKE
receiver, press and hold the Lock button of a pro-
grammed RKE transmitter depressed for five to ten
seconds.
(2) While holding the RKE transmitter Lock but-
ton depressed, press and release the RKE transmit-
ter Unlock button.
(3) The RKE horn chirp feature is now disabled.
Repeating the preceding steps will again enable
the RKE horn chirp feature.
REMOVAL AND INSTALLATION
DOOR MODULE
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the screws that secure the front door
trim panel to the inner door panel (Fig. 3).
(3) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the front door trim panel
away from the door around the perimeter to release
the trim panel retainers.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(4) Lift the front door trim panel upwards and
away from the inner door panel far enough to disen-
gage the top of the panel from the inner belt weath-
erstrip.
(5) Pull the front door trim panel away from the
inner door panel far enough to access the inside door
latch release and lock linkage rods near the back of
the inside door remote controls.
(6) Unsnap the plastic retainer clips from the
inside door remote control ends of the latch release
and lock linkage rods, and remove the rod ends from
the inside door remote controls.
(7) Unplug the wire harness connectors from the
door module.
(8) Remove the trim panel from the front door.
(9) Remove the three screws that secure the door
module to the front door trim panel (Fig. 4).
(10) Remove the door module from the front door
trim panel.
(11) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
POWER LOCK MOTOR
FRONT DOOR
The front door power lock motor is integral to the
front door latch unit. If the front door power lock
motor is faulty or damaged, the entire latch unit
must be replaced. Refer to Group 23 - Body for the
front door latch service procedures.
REAR DOOR
The rear door power lock motor is integral to the
rear door latch unit. If the rear door power lock
motor is faulty or damaged, the entire latch unit
must be replaced. Refer to Group 23 - Body for the
rear door latch service procedures.
Fig. 3 Front Door Trim Panel Remove/Install
1 – U-NUT
2 – DOOR
3 – TRIM PANEL
4 – PUSH-IN FASTENER
Fig. 4 Door Module Remove/Install
1 – INSIDE DOOR LATCH AND LOCK REMOTE CONTROLS
2 – CONNECTOR 1 RECEPTACLE
3 – DOOR MODULE
4 – CONNECTOR 2 RECEPTACLE
5 – SCREWS
6 – DOOR TRIM PANEL
XJ
POWER LOCK SYSTEMS
8P - 7
SERVICE PROCEDURES (Continued)