Jeep Cherokee 2000 Service Manual - page 1785
SUNVISORS
REMOVAL
(1) Remove the screws that attach the sunvisor
arm support bracket to the headliner and the roof
panel (Fig. 81) and (Fig. 82).
(2) Disconnect vanity lamp connector, if equipped.
(3) Detach the sunvisor from the support clip.
(4) Remove the sunvisor from the vehicle.
(5) Remove the retaining screw and support clip.
On vehicles equipped with an overhead console, the
support clip is integral with the overhead console.
INSTALLATION
(1) Install the support bracket and the retaining
screw.
(2) Connect vanity lamp connector, if equipped.
(3) Position the sunvisor in the support clip and
align the arm support bracket holes with the head-
liner holes.
(4) Install the screws that attach the sunvisor arm
support bracket to the headliner and the roof panel.
HEADLINER
The upper trim moldings and the headliner are
attached to the roof rail with a combination of
screws, clip retainers and rail retainers (Fig. 83).
To remove a headliner, all of the upper trim mold-
ings must be removed from the perimeter of the
headliner along with (as applicable):
•
Assist handles.
•
Sunvisors.
•
Dome/cargo lamps.
•
Overhead console.
•
All other attached/overlapping components.
Fig. 81 Sunvisor
1 – HEADLINER
2 – VEHICLE ROOF
3 – HEADLINER
4 – SUPPORT CLIP
5 – SCREW
6 – SUN VISOR
7 – SCREW
8 – SUN VISOR ARM SUPPORT BRACKET
Fig. 82 Sunvisor w/Vanity Lamp
1 – HEADLINER
2 – SUPPORT CLIP
3 – SUNVISOR
Fig. 83 Headliner Trim Moldings
1 – ROOF RAIL
2 – HEADLINER MOULDING
3 – SCREW
4 – SPACER
5 – LIFTGATE PILLAR TRIM COVER
6 – ASSIST HANDLE
7 – SCREW
8 – ASSIST HANDLE
9 – WINDSHIELD SIDE MOULDING
10 – COVER PLUG
11 – SCREW
23 - 60
BODY
XJ
REMOVAL AND INSTALLATION (Continued)