Jeep Cherokee 2000 Service Manual - Nv3550 Manual Transmission
TRANSMISSION AND TRANSFER CASE
TABLE OF CONTENTS
page
page
NV3550 MANUAL TRANSMISSION . . . . . . . . . . . . 1
NV231 TRANSFER CASE . . . . . . . . . . . . . . . . . . . . 5
NV3550 MANUAL TRANSMISSION
TABLE OF CONTENTS
page
page
REMOVAL AND INSTALLATION
TRANSMISSION - 2.5L TURBO DIESEL
ENGINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
SPECIFICATIONS
TORQUE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
REMOVAL AND INSTALLATION
TRANSMISSION - 2.5L TURBO DIESEL ENGINE
REMOVAL
1. Disconnect and isolate the negative battery
cable.
2. Remove the floor console, shifter boot and
shifter. Refer to group 23, Body for the procedure.
3. Raise the vehicle on a hoist.
4. Drain the transmission fluid (Fig. 1).
5. Remove exhaust pipe and heat shield.
6. Mark the front and rear propeller shafts for
installation alignment (Fig. 2).
7. Remove the front propeller shaft.
8. Remove the rear propeller shaft.
9. Remove the transmission skid plate.
10. Disconnect the transfer case linkage and vehi-
cle speed sensor electrical connector and vent tube
hose (Fig. 3).
11. Support the engine with an adjustable jack
stand.
12. Place a transmission jack under the transmis-
sion and secure the transmission with safety chains.
Fig. 1 Drain Plug and Backup Light Switch Location
1 – GEAR CASE
2 – BACKUP LIGHT SWITCH
3 – DRAIN PLUG
Fig. 2 Marking Propeller Shaft and Axle Yoke
1 – MARK BOTH YOKES FOR ALIGNMENT AT INSTALLATION
XJ
TRANSMISSION AND TRANSFER CASE
21 - 1