Jeep Cherokee 2000 Service Manual - page 336
service manual for the location of the proper starter
motor removal and installation procedures.
•
Starter Solenoid Visually inspect the starter
solenoid for indications of physical damage and loose
or corroded wire harness connections. Clean corroded
connections as required. Refer to Wiring Diagrams
in the index of this service manual for the location of
the proper wiring repair or connector and terminal
service procedures. Refer to Starter Motor in the
index of this service manual for the location of the
proper starter solenoid service procedures.
•
Wiring Visually inspect the starting system wire
harnesses for indications of physical damage. Repair
or replace any faulty wiring, as required. Refer to
Starting System in the index of this service manual
for the location of complete starting system wiring
diagrams. Refer to Wiring Diagrams in the index of
this service manual for the location of the proper wir-
ing repair or connector and terminal service proce-
dures.
SPECIFICATIONS
STARTING SYSTEM
Starter Motor and Solenoid
Manufacturer
Mitsubishi
Engine Application
2.5L, 4.0L
Power Rating
2.5L - 1.2 Kilowatt (1.6 Horsepower)
4.0L - 1.4 Kilowatt (1.9 Horsepower)
Voltage
12 Volts
Number of Fields
4
Number of Poles
4
Number of Brushes
4
Drive Type
Planetary Gear Reduction
Free Running Test Voltage
11.2 Volts
Free Running Test Maximum Amperage Draw
90 Amperes
Free Running Test Minimum Speed
2.5L - 2600 rpm
4.0L - 2500 rpm
Solenoid Closing Maximum Voltage Required
7.8 Volts
*Cranking Amperage Draw Test
2.5L - 130 Amperes
4.0L - 160 Amperes
*Test at operating temperature. Cold engine, tight (new) engine, or heavy oil will increase starter amperage draw.
XJ
STARTING SYSTEMS
8B - 15
CLEANING AND INSPECTION (Continued)