Jeep Cherokee 2000 Service Manual - page 1111
NOTE: Mark the position of the H-Block in relation
to the power steering pump and A/C Compressor so
it may be installed in its original position.
(8) Remove the (2) H-Block retaining bolts from
the power steering pump side of the block (Fig. 13).
(9) Support the A/C Compressor with mechanics
wire before proceeding to the next step.
(10) Remove the (4) A/C Compressor mounting
bolts (Fig. 13).
(11) Remove the remaining (2) bolts from H-Block
and remove the H-Block from the compressor.
(12) Position a jack stand and raise the weight off
the left engine mount.
(13) Remove the (2) engine mount upper sill plate
nuts.
(14) Remove the (4) engine mount bracket bolts
from the engine block.
(15) Remove the (2) engine mount lower sill plate
bolts.
(16) Remove the engine mount troughbolt.
(17) Remove the left engine mount from the vehi-
cle.
INSTALLATION—LEFT SIDE
(1) Position the engine mount and bracket in posi-
tion and install the engine mount through bolt and
nut, leaving them loose at this time.
(2) Install, but do not torque engine mount lower
sill plate bolts.
(3) Install the (4) engine mount bracket to engine
block retaining bolts. Torque to 61 N·m (45 ft. lbs.).
(4) Torque the (2) lower engine mount sill plate
bolts to 41 N·m (30 ft. lbs.).
(5) Install the (2) engine mount upper sill plate
nuts. Torque to 41 N·m (30 ft. lbs.).
(6) Remove the jack stand.
(7) Position the H-Block and the A/C Compressor
in there original positions and install the retaining
bolts (Fig. 14).
(8) Torque the A/C Compressor mounting bolts to
41 N·m (30 ft. lbs.) (Fig. 14).
(9) Torque all the H-Block bolts to 18 N·m (159 in.
lbs.) (Fig. 14).
(10) Torque the engine mount throughbolt nut to
65 N·m (48 ft. lbs.) (Fig. 14).
(11) Lower the vehicle from the hoist.
(12) Install the refrigerant line support bracket.
(13) Install the A/C filter-drier support bracket.
(14) Connect the negative battery cable.
Fig. 13 A/C Compressor Position & Orientation
1 – A/C COMPRESSOR MOUNTING BOLTS
2 – LEFT ENGINE MOUNT THROUGHBOLT NUT
3 – H BLOCK BOLTS
4 – COUPLER PINCH BOLT
5 – COMPRESSOR ELECTRICAL CONNECTOR
Fig. 14 A/C Compressor Position & Orientation
1 – A/C COMPRESSOR MOUNTING BOLTS
2 – LEFT ENGINE MOUNT THROUGHBOLT NUT
3 – H BLOCK BOLTS
4 – COUPLER PINCH BOLT
5 – COMPRESSOR ELECTRICAL CONNECTOR
XJ
ENGINE
9 - 17
REMOVAL AND INSTALLATION (Continued)