Jeep Cherokee 2000 Service Manual - page 1607
ASSEMBLY
(1) Install thrust washer in planetary gear (Fig.
221). Grooved side of washer faces up and
toward front.
(2) Install clutch race into planetary gear.
(3) Install one–way clutch into the outer race (Fig.
222). Be sure flanged side of clutch is facing upward.
(4) Install clutch retaining plate and snap ring in
planetary gear.
(5) Coat planetary race with petroleum jelly and
install it on planetary gear. Outside diameter of race
should be 41.8 mm (1.646 in.); inside diameter is 27.1
mm (1.067 in.).
(6) Install hub in planetary ring gear and install
snap ring.
(7) Coat race and bearing with petroleum jelly and
install in planetary ring gear (Fig. 223).
(8) Verify bearing/race size. Outside diameter of
race is 47.8 mm (1.882 in.) and inside diameter is
24.2 mm (0.953 in.). Outside diameter of bearing is
46.8 mm (1.843 in.) and inside diameter is 26 mm
(1.024 in.).
(9) Lubricate new clutch piston O–rings with
Mopar
t
Door Ease, or Ru–Glyde. Then install rings
on clutch piston and install piston in clutch drum.
(10) Install piston return springs in clutch piston
(Fig. 224).
(11) Install piston snap ring. Compress piston return
springs with Tool 7538 and shop press (Fig. 225).
(12) Install overdrive clutch pack in drum. Install
steel plate first, then a disc (Fig. 226). Continue
Fig. 222 Assembling One–Way Clutch And Race
1 – FLANGED SIDE OF CLUTCH FACES UP
2 – ONE-WAY CLUTCH
3 – CLUTCH RACE
Fig. 223 Install Ring Gear Bearing And Race
1 – BEARING
2 – RACE
3 – RING GEAR
Fig. 221 Install Planetary Thrust Washer
1 – THRUST WASHER
2 – PLANETARY GEAR
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 307
DISASSEMBLY AND ASSEMBLY (Continued)