Jeep Cherokee 2000 Service Manual - page 1560
(10) Apply bead of Threebond
t
Liquid Gasket
TB1281, P/N 83504038 to sealing surface of oil pan.
Sealer bead should be at least 3 mm (1/8 in.) wide.
Then install oil pan and tighten pan bolts to 7.4 N·m
(65 in. lbs.) torque.
(11) Install new gasket on oil pan drain plug and
install plug in pan. Tighten plug to 20 N·m (15 ft.
lbs.) torque.
(12) Fill transmission with Mopar
t
Dexron IIE/
Mercon.
TRANSMISSION CONTROL MODULE
The transmission control module is mounted under
the instrument panel. On left hand drive models, it is
at the driver side of the lower finish panel (Fig. 70).
On right hand drive models, it is at the passenger
side of the lower finish panel (Fig. 71).
To remove the module, disconnect the wire har-
ness, remove the mounting screws and remove the
Fig. 65 Transmission Valve Body Bolt Locations
Fig. 66 Accumulator Springs
1 – OVERDRIVE BRAKE ACCUMULATOR SPRING
2 – SECOND BRAKE ACCUMULATOR SPRING
Fig. 67 Removing/Installing Check Ball And Spring
1 – CHECK BALL AND SPRING
Fig. 68 Shift Sector And Manual Valve Alignment
1 – MANUAL VALVE
2 – SHIFT SECTOR
21 - 260
AW–4 AUTOMATIC TRANSMISSION
XJ
REMOVAL AND INSTALLATION (Continued)