Jeep Cherokee 2000 Service Manual - page 1462
(33) Insert connecting tube into converter clutch
valve module (Fig. 114).
(34) Insert connecting tube into valve body open-
ing (Fig. 115).
(35) Place converter clutch valve module in posi-
tion on separator plate. Install screws to attach con-
verter clutch module to valve body (Fig. 115).
(36) If necessary, install a new O-ring on converter
clutch solenoid (Fig. 116).
(37) Insert converter clutch solenoid into transfer
plate (Fig. 116).
(38) Install screw to attach solenoid to transfer
plate (Fig. 116).
(39) If necessary, insert park rod end into manual
lever and install E-clip (Fig. 117).
(40) Insert detent spring and ball into opening in
valve body and install Retainer Tool 6583 (Fig. 118).
(41) Install manual valve into valve body (Fig.
119).
(42) Insert throttle lever through transfer plate
side of valve body and upward (Fig. 120).
(43) Insert throttle lever into groove in manual
valve (Fig. 121).
(44) Install seal, washer, and E-clip to retain man-
ual shaft to valve body (Fig. 120).
(45) Install switch valve and spring, pressure reg-
ulator valve and spring, kickdown valve and spring,
and throttle valve into valve body (Fig. 122).
Fig. 111 Transfer And Separator Plates
1 – SEPARATOR PLATE
2 – FILTER
3 – TRANSFER PLATE
Fig. 112 Correct Position Of Valve Body Check Balls
1 – 1/4
88
CHECK BALLS (6)
2 – 11/32
88
CHECK BALL (1)
Fig. 114 Converter Clutch Valve Module
1 – COVER PLATE
2 – CONVERTER CLUTCH VALVE
3 – TORQUE CONVERTER CLUTCH MODULE
4 – MODULE CONNECTING TUBE
5 – FAIL-SAFE VALVE
Fig. 115 Clutch Module And Connecting Tube
1 – MODULE AND CONNECTING TUBE
21 - 162
AUTOMATIC TRANSMISSION—30RH
XJ
DISASSEMBLY AND ASSEMBLY (Continued)