Jeep Cherokee 2000 Service Manual - page 1296
(1) Transfer the pressure line to the new pump,
making sure line is in original position.
(2) Transfer the coupler to the new pump leaving
pinch bolt lose at this time (Fig. 5).
(3) Install the power steering pump (Fig. 5).
(4) Install the engine mount and the engine mount
bracket in the vehicle.
(5) Install the engine mount throughbolt and leave
loose at this time.
(6) Install, but do not torque the engine mount
and track bar support bracket bolts (Fig. 6).
(7) Install the (4) engine mount bracket to engine
block retaining bolts. Torque bolts to 47 N·m (35 ft.
lbs.).
(8) Torque the engine mount sill plate bolts to 41
N·m (30 ft. lbs.).
(9) Torque the larger trackbar support bracket
bolts to 125 N·m (92ft. lbs.).
(10) Remove the jack stand.
(11) Install the H-Block on the A/C compressor in
its original position and leave the bolts loose at this
time.
(12) Position and install the A/C compressor.
(13) Slide the drive coupler in its original position
and install the remaining (2) H-Block bolts.
(14) Install the power steering pump pulley (Fig.
7). Torque nut to 166 N·m (120 ft. lbs.).
(15) Install the accessory drive belt. See Group 7,
Cooling System for procedure.
(16) Torque all the H-Block bolts.
Fig. 4 Power Steering Pump
1 – ENGINE BLOCK
2 – COUPLER
3 – COUPLER PINCH BOLT
4 – POWER STEERING PUMP RETAINING NUTS
Fig. 5 Power Steering Pump
1 – ENGINE BLOCK
2 – COUPLER
3 – COUPLER PINCH BOLT
4 – POWER STEERING PUMP RETAINING NUTS
Fig. 6 Engine Mount Retaining Bolts
1 – TRACK BAR SUPPORT BRACKET RETAINING BOLTS
2 – ENGINE MOUNT SILL PLATE BOLT
19 - 4
STEERING
XJ
REMOVAL AND INSTALLATION (Continued)