Jeep Cherokee 2000 Service Manual - page 479
(4) Disconnect the headlamp leveling motor electri-
cal connector.
(5) Rotate the leveling motor 90 degrees until
motor is loose in mounting bracket.
(6) Tilt motor upwards to disconnect motor push
rod from the headlamp leveling linkage.
(7) Remove the headlamp leveling motor from the
vehicle (Fig. 3).
INSTALLATION
(1) Install leveling motor push rod through hole in
mounting bracket and connect push rod on leveling
linkage. The proper angle must be achieved to con-
nect the push rod onto the leveling linkage.
(2) Once the push rod is connected, rotate motor
until tabs line up with tabs in mounting bracket.
Once the tabs are lined up push and rotate the motor
90 degrees to lock in place.
(3) Connect the headlamp leveling motor electrical
connector.
(4) Position the front splash shield.
(5) Lower the vehicle and connect the negative
battery cable.
SIDE REPEATER LAMP
REMOVAL
(1) Grip the side repeater lamp assembly and pull
straight from the fender.
(2) Rotate and pull the socket from the housing
(Fig. 4).
INSTALLATION
(1) Push and rotate the socket into the housing.
(2) Verify lamp operation.
(3) Press the lamp assembly into the fender
mounting hole.
FRONT FOG LAMP
REMOVAL
1. Remove the 2 screws from the bottom cover of
the lamp body.
2. Disconnect the 2 wires from the lamp element.
3. Remove the lamp element from the housing.
INSTALLATION
1. Install the new lamp element in the housing
and reinstall the lower housing.
REAR TURN SIGNAL, BACKUP, TAILLAMP AND
FOG LAMP
REMOVAL
(1) There are 3 mounting bolts attaching the tail-
light assembly. When removing, unfasten the 3 bolts
located on the top and side. Lift up and out to
remove the assembly.
(2) Turn the socket assembly 1/3 turn and pull the
socket from the housing (Fig. 5).
INSTALLATION
(1) Install the four lamp sockets in the taillamp
assembly.
(2) Verify lamp operation.
(3) Position the taillamp assembly and install the
retaining screws.
LICENSE PLATE LAMP
REMOVAL
(1) Remove the appropriate license plate lamp
retaining screws.
(2) Pull lamp housing from rear liftgate. Lamp
must be positioned properly to allow removal without
removing license plate.
(3) Rotate the lamp socket counter clockwise and
pull straight from lamp housing.
Fig. 4 Side Repeater Lamp
Fig. 5 Rear Lamp Replacement
XJ
LAMPS
8L - 9
REMOVAL AND INSTALLATION (Continued)