Jeep Cherokee 2000 Service Manual - page 1482
(4) Remove top pressure plate, clutch discs, steel
plates, bottom pressure plate and wave snap ring
and wave spring (Fig. 190).
(5) Remove clutch piston with rotating motion.
(6) Remove and discard piston seals.
(7) Remove input shaft snap-ring (Fig. 191). It
may be necessary to press the input shaft in slightly
to relieve tension on the snap-ring
(8) Press input shaft out of retainer with shop
press and suitable size press tool. Use a suitably
Fig. 185 Compressing Front Clutch Piston Spring
1 – FRONT CLUTCH SPRING
2 – COMPRESSOR TOOL C-3575–A
3 – RETAINER SNAP RING
4 – SPRING RETAINER
Fig. 186 Front Clutch Piston Installation
1 – CLUTCH PISTON
2 – FRONT CLUTCH RETAINER
Fig. 187 Clutch Piston Spring Installation
1 – RETAINER
2 – CLUTCH SPRING
3 – PISTON
Fig. 188 Correct Spring Retainer Installed Position
1 – SMALL TABS ON RETAINER FACE UPWARD
Fig. 189 Measuring Front Clutch Pack Clearance
1 – DIAL INDICATOR
2 – WAVED SNAP-RING
3 – FRONT CLUTCH
4 – POINTER
5 – GAUGE BAR
6 – PRESSURE PLATE
21 - 182
AUTOMATIC TRANSMISSION—30RH
XJ
DISASSEMBLY AND ASSEMBLY (Continued)