Jeep Cherokee 2000 Service Manual - page 1299
(5) Install the engine mount throughbolt and leave
loose at this time.
(6) Install, do not torque engine mount sill plate
nuts and bolts.
(7) Install (4) engine mount bracket to engine
block retaining bolts and Torque to 61 N·m (45 ft.
lbs.).
(8) Torque the engine mount sill plate nuts to 41
N·m (30 ft. lbs.).
(9) Torque the engine mount sill plate bolts to 41
N·m (30 ft. lbs.).
(10) Remove jack stand.
(11) Install the H-Block on the A/C compressor in
the original position and leave bolts loose at this
time.
(12) Position and install A/C compressor.
(13) Slide the drive coupler into its original posi-
tion and start remaining (2) H-Block bolts.
(14) Install the power steering pump pulley (Fig.
12). Torque nut to 166 N·m (120 ft. lbs.).
(15) Install the accessory drive belt. See Group 7,
Cooling for procedure.
(16) Torque all the H-Block bolts.
(17) Torque the engine mount throughbolt nut to
65 N·m (48 ft. lbs.).
(18) Install the power steering fluid supply hose on
pump.
(19) Install
the
power
steering
line
support
bracket bolt.
(20) Lower the vehicle from hoist.
(21) Install the refrigerent line support bracket
and bolt on the top of the radiator.
(22) Install the A/C filter-drier assembly support
bracket nuts on the left fender well.
(23) Reconnect the A/C compressor electrical con-
nector.
(24) Re-fill the power steering fluid. Refer to
Group 19, Steering for Power Steering Pump-Initial
Operation for procedure.
(25) Connect the negative battery cable.
STEERING GEAR - RHD
REMOVAL
(1) Open the hood and disconnect the negative bat-
tery cable.
(2) Place the front wheels in the straight ahead
position and lock the steering wheel.
CAUTION: Be certain to lock the steering wheel in
position prior to disconnecting the steering column
coupler. This will prevent clockspring damage.
(3) Disconnect the power steering pressure and
return lines from the steering gear (Fig. 13).
(4) Remove the steering column coupler pinch bolt.
Located just to the rear of the fluid lines (Fig. 13).
Fig. 12 Installing Pump Pulley
1 – LEVERAGE PIPE
2 – HEX WRENCH
3 – POWER STEERING PUMP PULLEY
4 – BOX WRENCH
Fig. 13 Power Steering Fluid Pressure and Return
Line Location – RHD
1 – POWER STEERING FLUID RETURN LINE
2 – POWER STEERING FLUID PRESSURE LINE
3 – AIR FILTER COVER
XJ
STEERING
19 - 7
REMOVAL AND INSTALLATION (Continued)