Jeep Cherokee 2000 Service Manual - Lamp Service
LAMP SERVICE
TABLE OF CONTENTS
page
page
REMOVAL AND INSTALLATION
HEADLAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
FOG LAMP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
FRONT PARK/TURN SIGNAL LAMP . . . . . . . . . . . 15
SIDE MARKER LAMP. . . . . . . . . . . . . . . . . . . . . . 15
BACK-UP/BRAKE/REAR TURN SIGNAL/TAIL
LAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
LICENSE PLATE LAMP . . . . . . . . . . . . . . . . . . . . 16
UNDERHOOD LAMP . . . . . . . . . . . . . . . . . . . . . . 16
CARGO LAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
MAP/READING LAMP . . . . . . . . . . . . . . . . . . . . . 17
VISOR VANITY LAMP. . . . . . . . . . . . . . . . . . . . . . 18
REMOVAL AND INSTALLATION
HEADLAMP
REMOVAL
(1) Remove the screws attaching the bezel to the
grille opening panel
(2) Remove the screws attaching the retaining ring
to the headlamp bucket.
(3) Disconnect the headlamp bulb wire harness
connector (Fig. 1).
(4) Separate the bulb from the vehicle.
(5) Remove the spring attaching the headlamp
bucket to the grille opening panel (Fig. 2).
(6) Slide the headlamp bucket downward to disen-
gage it from the headlamp adjusting screws.
INSTALLATION
(1) Position the headlamp bucket in the grille
opening panel and slide the headlamp bucket upward
to engage it with the headlamp adjusting screws.
(2) Install the spring attaching the headlamp
bucket to the grille opening panel.
(3) Connect the wire harness connector.
(4) Position the bulb in the bucket.
(5) Position retaining ring on the headlamp bulb
and install screws.
(6) Install the headlamp bezel.
Fig. 1 Headlamp Connector
1 – HEADLAMP CONNECTOR
2 – PARK/TURN LAMP BULB
3 – SIDE MARKER LAMP BULB
Fig. 2 Headlamp
1 – HEADLAMP ADJUSTMENT
2 – NUT
3 – HEADLAMP
4 – BEZEL
5 – PARK/TURN LAMP
6 – SPRING
7 – BUMPER
8L - 14
LAMPS
XJ