Jeep Cherokee 2000 Service Manual - page 435
Other manuals for Cherokee 2000:
Service Manual
of
1970
(9) Install and tighten the three screws that secure
the lower steering column shroud to the upper
shroud. Tighten the screws to 2 N·m (18 in. lbs.).
(10) If the vehicle is so equipped, tighten the two
nuts that secure the non-tilt steering column upper
mounting bracket to the dash panel steering column
support bracket studs. Tighten the nuts to 22 N·m
(200 in. lbs.).
(11) Install the knee blocker onto the instrument
panel. Refer to Knee Blocker in the Removal and
Installation section of Group 8E - Instrument Panel
Systems for the procedures.
(12) Reconnect the battery negative cable.
8J - 8
TURN SIGNAL AND HAZARD WARNING SYSTEMS
XJ
REMOVAL AND INSTALLATION (Continued)