Jeep Cherokee 2000 Service Manual - page 477
INSTALLATION
(1) Align the side repeater lamp bulb to the socket
(Fig. 4).
(2) Push the bulb into the socket.
(3) Verify lamp operation.
(4) Push and rotate the socket into the housing.
(5) Press the lamp assembly into the fender
mounting hole.
REAR FOG LAMP BULB
REMOVAL
(1) There are 3 mounting bolts attaching the tail-
light assembly. When removing, unfasten the 3 bolts
located on the top and side. Lift up and out to
remove the assembly.
(2) Turn the socket assembly 1/3 turn and pull the
socket from the housing (Fig. 5).
(3) Pull the rear fog lamp straight from its socket.
INSTALLATION
(1) Install rear fog lamp bulb in its socket.
(2) Verify lamp operation.
(3) Install the remaining three lamp sockets in the
taillamp assembly.
(4) Position the taillamp assembly and install the
retaining screws.
LICENSE PLATE LAMP BULB
REMOVAL
(1) Remove the appropriate license plate lamp
retaining screws.
(2) Pull lamp housing from rear liftgate. Lamp
must be positioned properly to allow removal without
removing license plate.
(3) Rotate the lamp socket counter clockwise and
pull straight from lamp housing.
(4) Pull the lamp bulb straight from its socket.
INSTALLATION
(1) Install bulb in lamp socket.
(2) Verify lamp operation.
(3) Install lamp socket in lamp housing.
(4) Install license plate lamp assembly in liftgate
and install retaining screws.
Fig. 4 Side Repeater Lamp
Fig. 5 Rear Lamp Replacement
XJ
LAMPS
8L - 7
REMOVAL AND INSTALLATION (Continued)