Jeep Cherokee 2000 Service Manual - page 345
BATTERY TEMPERATURE SENSOR
The battery temperature sensor is located under
vehicle battery (Fig. 5) and is attached to a mounting
hole on battery tray.
REMOVAL
(1) Remove battery. Refer to Group 8A, Battery for
procedures.
(2) Disconnect sensor pigtail harness from engine
wire harness.
(3) Pry sensor straight up from battery tray
mounting hole.
INSTALLATION
(1) Feed pigtail harness through hole in top of bat-
tery tray and press sensor into top of battery tray.
(2) Connect pigtail harness.
(3) Install battery. Refer to Group 8A, Battery for
procedures.
SPECIFICATIONS
GENERATOR RATINGS
TYPE
PART NUMBER
RATED SAE AMPS
ENGINES
MINIMUM TEST AMPS
DENSO
56041685AA
117
4.0L
88
DENSO
56041565AA
81
4.0L
57
DENSO
56005684AB
81
2.5L
57
DENSO
56005685AC
117
2.5L
88
DENSO
56041822AA
124
2.5L/4.0L
90
TORQUE CHART
Right Hand Drive= RHD, Left Hand Drive= LHD.
Description
Torque
Generator Mounting Bolt—LHD—2.5L/4.0L
Engine . . . . . . . . . . . . . . . . . . 55 N·m (41 ft. lbs.)
Generator Pivot Bolt/Nut—LHD—2.5L/4.0L
Engine . . . . . . . . . . . . . . . . . . 55 N·m (41 ft. lbs.)
Battery Terminal Nut—LHD or
RHD . . . . . . . . . . . . . . . . . . 8.5 N·m (75 in. lbs.)
Description
Torque
Ground Terminal Nut—LHD or
RHD . . . . . . . . . . . . . . . . . . 8.5 N·m (75 in. lbs.)
Harness Hold-down Nut—LHD or
RHD . . . . . . . . . . . . . . . . . . 8.5 N·m (75 in. lbs.)
Field Terminal Nuts—LHD or
RHD . . . . . . . . . . . . . . . . . . 2.8 N·m (25 in. lbs.)
Fig. 5 Battery Temperature Sensor
1 – BATTERY TEMPERATURE SENSOR
2 – BATTERY TRAY
XJ
CHARGING SYSTEM
8C - 5
REMOVAL AND INSTALLATION (Continued)