Jeep Cherokee 2000 Service Manual - page 543
(5) Remove the two screws that secure the front of
the seat adjuster frame to the floor panel seat
mounting reinforcement (Fig. 4).
(6) Remove the screw that secures the outboard
rear of the seat adjuster frame to the floor panel.
(7) Remove the nut that secures the inboard rear
of the seat adjuster frame to the stud on the floor
panel.
(8) Remove the seat and the power seat adjuster
and motors assembly from the vehicle as a unit.
(9) Remove the four nuts that secure the power
seat adjuster and motors assembly to the seat cush-
ion frame (Fig. 5).
(10) Remove the power seat switch from the out-
board side of the seat. Refer to Power Seat Switch
in the index of this service manual for the location of
the proper power seat switch removal and installa-
tion procedures.
(11) Disengage the power seat switch wire harness
and connector from the seat cushion frame.
(12) Remove the power seat adjuster and motors
assembly from the seat cushion frame.
(13) Reverse the removal procedures to install.
Tighten the seat mounting hardware as follows:
•
Seat adjuster to seat cushion frame nuts - 25
N·m (18 ft. lbs.)
•
Seat adjuster to floor panel screws - 27 N·m (20
ft. lbs.)
•
Seat adjuster to floor panel nut - 40 N·m (30 ft.
lbs.).
Fig. 3 Driver Seat Belt Switch Connector
1 – DRIVER SIDE FRONT SEAT
2 – SEAT BELT SWITCH CONNECTOR
3 – BODY WIRE HARNESS CONNECTOR
Fig. 4 Power Seat Remove/Install
1 – NUT
2 – DRIVER SIDE FRONT SEAT
3 – SCREW
4 – STUD
5 – SCREW
Fig. 5 Power Seat Adjuster and Motors Remove/
Install
1 – POWER SEAT ADJUSTER AND MOTORS
2 – SEAT CUSHION FRAME
3 – SEAT CUSHION FRAME
8R - 4
POWER SEAT SYSTEMS
XJ
REMOVAL AND INSTALLATION (Continued)