Jeep Cherokee 2000 Service Manual - page 529
OVERHEAD CONSOLE MOUNTED TYPE
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the overhead console from the head-
liner. Refer to Overhead Console in Group 8V - Over-
head Console Systems for the procedures.
(3) Remove the six screws that secure the rear
overhead console housing to the overhead console
bezel (Fig. 7).
(4) Gently flex the sides of the overhead console
bezel far enough to clear the tabs on the rear console
housing and remove the housing from the bezel.
(5) Remove the two screws that secure the RKE
receiver circuit board to the rear overhead console
housing.
(6) Remove the RKE circuit board from the rear
overhead console housing.
(7) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
Fig. 7 RKE Receiver Remove/Install
1 – REAR OVERHEAD CONSOLE HOUSING
2 – RKE RECEIVER
3 – TABS
4 – OVERHEAD CONSOLE BEZEL
5 – SCREWS
XJ
POWER LOCK SYSTEMS
8P - 9
REMOVAL AND INSTALLATION (Continued)