Jeep Cherokee 2000 Service Manual - page 1783
(3) Open the console lid.
(4) Remove the screws attaching the console to the
floor and mounting bracket (Fig. 77).
(5) Disconnect the wire harness connector.
(6) Separate the console from the floor.
INSTALLATION
(1) Position the console on the floor.
(2) Attach the air duct to the air outlet duct.
(3) Connect the wire harness connectors.
(4) Install the screws attaching the console to the
mounting bracket.
(5) Install the shift indicator bezels (or cover
plate).
(6) Install the shift lever handle/knob.
FRONT CARPET/MAT
REMOVAL
(1) Remove the door sill inner scuff plates.
(2) Remove the front and rear seats (as applica-
ble).
(3) Remove floor console.
(4) As necessary, remove the trim panels and
moldings.
(5) Remove all other interfering components.
(6) Remove the carpet and mat from the floor
panel (Fig. 78).
INSTALLATION
(1) Position the carpet and mat on the floor panel.
(2) Install all the components that were removed
to facilitate carpet/mat removal.
(3) Install the trim panels and moldings.
(4) Install the door sill inner scuff plates.
(5) Install floor console.
(6) Install the front and rear seats (as applicable).
REAR CARPET/MAT
REMOVAL
(1) Remove the liftgate latch striker and scuff
plate.
(2) Drill-out the retaining rivet heads and remove
the cargo tie-down footman loops from the carpet.
(3) As necessary, remove the trim panels and
moldings.
(4) Remove the all other interfering components.
(5) Remove the carpet and mat from the floor
panel.
(6) If necessary, remove the insulation from the
wheelhouse (Fig. 79).
INSTALLATION
(1) If removed, install the insulation on the wheel-
houses.
(2) Position the mat on the floor panel.
(3) Position the carpet on the mat.
(4) Install all the components that were removed
to facilitate carpet and mat removal.
(5) Install the trim panels and moldings.
(6) Install the cargo tie-down footman loops on the
carpet with replacement rivets.
(7) Install the liftgate scuff plate and latch striker.
Fig. 77 Floor Console
1 – TRANSFER CASE SHIFT BEZEL
2 – COVER
3 – TRANS SHIFT BEZEL
4 – FLOOR CONSOLE
5 – WASHER (2WD)
6 – BRACKET
7 – DUCT
Fig. 78 Front Carpet and Mat
1 – CARPET AND MAT
2 – POWER SEAT WIRE HARNESS SLOT
3 – FLOOR PANEL
4 – SEAT FRAME STUD
23 - 58
BODY
XJ
REMOVAL AND INSTALLATION (Continued)