Jeep Cherokee 2000 Service Manual - page 539
Other manuals for Cherokee 2000:
Service Manual
of
1970
(14) Remove the SKIM from the vehicle.
(15) Reverse the removal procedures to install.
Tighten the non-tilt steering column mounting nuts
to 22 N·m (200 in. lbs.) and the steering column
shroud mounting screws to 2 N·m (18 in. lbs.).
(16) If the SKIM is replaced with a new unit, a
DRB scan tool and the proper Diagnostic Procedures
manual MUST be used to initialize the new SKIM
and
to
program
at
least
two
Sentry
Key
transponders.
Fig. 3 Sentry Key Immobilizer Module Remove/Install
1 – UPPER SHROUD
2 – STEERING COLUMN
3 – WIRE HARNESS CONNECTOR
4 – SENTRY KEY IMMOBILIZER MODULE
5 – IGNITION LOCK CYLINDER
6 – SCREW
7 – LOWER SHROUD
8 – STEERING WHEEL
XJ
VEHICLE THEFT/SECURITY SYSTEMS
8Q - 5
REMOVAL AND INSTALLATION (Continued)