Jeep Cherokee 2000 Service Manual - page 1768
(2) Position the waterdam on the door, apply adhe-
sive as necessary and press into place.
(3) Install door trim panel.
REAR DOOR
REMOVAL
(1) Remove door restraint (check) retaining pin.
(2) For vehicles equipped with power windows and
power door locks, remove trim panel and waterdam.
Disconnect all components and route wire harness
out of door.
(3) Remove bolts attaching hinge to door face.
(4) Separate door from vehicle.
INSTALLATION
(1) Position door in body opening.
(2) Align door hinges, plates and shims and install
bolts. Tighten bolts to 3 N·m (2 ft. lbs.) torque.
(3) Install door restraint (check).
(4) If applicable, route and connect wire harness
connectors.
(5) If necessary, install door waterdam and trim
panel.
REAR DOOR RESTRAINT
REMOVAL
(1) Remove the door trim panel.
(2) Remove the door restraint (check) retaining pin
from the bracket with a punch.
(3) Remove the nuts and remove the restraint via
the access opening in the door inner panel (Fig. 48).
INSTALLATION
(1) Position the door restraint in the door by way
of the opening and install the nuts. Tighten the nuts
to 10 N·m (7 ft-lbs) torque.
(2) Position the door restraint in bracket with the
holes aligned and insert the retaining pin.
REAR DOOR HINGE
REMOVAL
(1) Remove door restrain (check) pin.
(2) Remove door hinge bolts and shims.
(3) Retain bolts and shims for correct installation.
Fig. 45 Detaching Trim Panel Push-In Fasteners
Fig. 46 Latch Rods
1 – INSIDE HANDLE TO LATCH ROD
2 – INSIDE HANDLE ACTUATOR
3 – CLIP
4 – LOCK TO LATCH ROD
Fig. 47 Push-In Fasteners
1 – LOCATING PINS
2 – PUSH-IN FASTENERS
XJ
BODY
23 - 43
REMOVAL AND INSTALLATION (Continued)