Jeep Cherokee 2000 Service Manual - page 412
(4) Unscrew the antenna mast from the antenna
body (Fig. 13).
(5) Remove the antenna cap nut and adapter using
an antenna nut wrench (Special Tool C-4816) (Fig.
14).
(6) Lower the antenna body and cable assembly
through the top of the fender far enough to access
the antenna body by reaching up into the rear of the
right front fender wheel housing (Fig. 15).
(7) Disengage the coaxial cable grommet from the
hole in the right cowl side outer panel.
(8) Pull the coaxial cable out through the right
cowl side outer panel.
(9) Remove the antenna body and cable from the
vehicle.
(10) Reverse the removal procedures to install.
Tighten the antenna cap nut to 6.2 N·m (55 in. lbs.).
Tighten the antenna mast to 3.3 N·m (30 in. lbs.).
RADIO NOISE SUPPRESSION COMPONENTS
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
REFER
TO
GROUP
8M
-
PASSIVE
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING
WHEEL,
STEERING
COLUMN,
OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
REMOVAL
ENGINE-TO-BODY GROUND STRAP
(1) Remove the screw that secures the engine-to-
body ground strap eyelet to the dash panel (Fig. 16).
Fig. 13 Antenna Mast Remove/Install - Typical
1 – ANTENNA MAST
2 – ADAPTER
3 – CAP NUT
Fig. 14 Antenna Cap Nut and Adapter Remove/
Install - Typical
1 – CAP NUT
2 – ANTENNA ADAPTER
3 – TOOL
Fig. 15 Antenna Mounting
1 – NUT
2 – MAST
3 – RIGHT FRONT FENDER
4 – ANTENNA BODY AND CABLE
5 – GROMMET
6 – ADAPTER
XJ
AUDIO SYSTEMS
8F - 11
REMOVAL AND INSTALLATION (Continued)