Jeep Cherokee 2000 Service Manual - page 16
CAUTION: Do not attempt to lift a Jeep vehicle with
a floor jack positioned under:
•
An axle tube.
•
A body side sill.
•
A steering linkage component.
•
A drive shaft.
•
The engine or transmission oil pan.
•
The fuel tank.
•
A front suspension arm.
NOTE: Use the correct sub-frame rail or frame rail
lifting locations only.
HOIST
A vehicle can be lifted with:
•
A single-post, frame-contact hoist.
•
A twin-post, chassis hoist.
•
A ramp-type, drive-on hoist.
NOTE: When a frame-contact type hoist is used,
verify that the lifting pads are positioned properly.
WARNING: THE
HOISTING
AND
JACK
LIFTING
POINTS PROVIDED ARE FOR A COMPLETE VEHI-
CLE. WHEN A CHASSIS OR DRIVETRAIN COMPO-
NENT
IS
REMOVED
FROM
A
VEHICLE,
THE
CENTER OF GRAVITY IS ALTERED MAKING SOME
HOISTING
CONDITIONS
UNSTABLE.
PROPERLY
SUPPORT OR SECURE VEHICLE TO HOISTING
DEVICE WHEN THESE CONDITIONS EXIST.
Fig. 3 Correct Vehicle Lifting Locations
1 – SUB-FRAME RAIL LOCATION
2 – SUB-FRAME RAIL LOCATION
0 - 12
LUBRICATION AND MAINTENANCE
XJ
SERVICE PROCEDURES (Continued)