Jeep Cherokee 2000 Service Manual - page 1272
(3) Install the pump hoses.
(4) Fill reservoir to proper level. Refer to Power
Steering Pump Initial Operation.
DISASSEMBLY AND ASSEMBLY
PUMP PULLEY
DISASSEMBLY
(1) Remove pump assembly.
(2) Remove pulley from pump with Puller C-4333
or equivalent puller (Fig. 5).
ASSEMBLY
NOTE: The pulley is marked front for installation.
(1) Replace pulley if bent, cracked, or loose.
(2) Install pulley on pump with Installer C-4063-B
or equivalent installer (Fig. 6). The pulley must be
flush with the end of the shaft. Ensure the tool and
pulley are aligned with the pump shaft.
(3) Install pump assembly.
(4) With Serpentine Belt, run engine until warm (5
min.) and note any belt chirp. If chirp exists, move
pulley outward approximately 0.5 mm (0.020 in.). If
noise increases, press on 1.0 mm (0.040 in.). Be
careful that pulley does not contact mounting
bolts.
PUMP RESERVOIR
DISASSEMBLY
(1) Remove power steering pump.
(2) Clean exterior of pump.
(3) Clamp the pump body in a soft jaw vice.
(4) Pry up tab and slide the retaining clips off (Fig.
7).
NOTE: Use new retaining clips for installation.
(5) Remove
fluid
reservoir
from
pump
body.
Remove and discard O-ring seal.
ASSEMBLY
(1) Lubricate new O-ring Seal with Mopar Power
Steering Fluid or equivalent.
Fig. 3 Pump Mounting LHD
1 – PUMP BRACKET
2 – PUMP ASSEMBLY 2.5L
3 – PUMP ASSEMBLY 4.0L
19 - 8
STEERING
XJ
REMOVAL AND INSTALLATION (Continued)