Jeep Cherokee 2000 Service Manual - page 1741
BUCKET SEATBACK COVER
REMOVAL
(1) Remove seat.
(2) Remove head restraint, if equipped.
(3) Remove screws attaching side shield trim cover
to bucket seat.
(4) If equipped, disengage power seat wire connec-
tor from power seat switch.
(5) Remove the inboard seatback pivot bolt and
large plastic washer.
(6) Position the seatback in the full forward or full
recline position.
(7) Remove the seatback cover J straps from the
base of the seatback.
(8) Roll the seatback cover upward, disengage elec-
trical connectors for heated seat grid, if equipped.
(Fig. 8).
(9) Disengage the hogrings attaching the seatback
cover to the seatback cushion support wires (Fig. 9).
(10) Roll the seatback cover upward and disengage
the hook and loop fastener (Fig. 10).
(11) Roll seatback cover up and over the head
restraint sleeves, if equipped and separate from the
seatback.
INSTALLATION
(1) Position the seatback cover on the seatback
cushion and roll seatback cover down over the head
restraint sleeves. Route the sleeves through the
access holes in the cover, if equipped.
(2) Roll the seatback cover downward and engage
the hook and loop fastener. Engage electrical connec-
tors for heated seat grid, if equipped.
(3) Continue rolling the cover downward and
engage the hogrings attaching the seatback cover to
the seatback cushion support wires.
(4) Engage the seatback cover J straps to the base
of the seatback.
(5) Install the inboard seatback pivot bolt and
large plastic washer.
(6) Install the side shield trim cover.
(7) Install head restraint, if equipped.
(8) Install seat.
BUCKET SEATBACK
REMOVAL
(1) Remove seat.
(2) Remove side shield trim cover.
(3) Remove
inboard
seatback
pivot
bolt
and
washer.
Fig. 8 Seatback Cover
1 – SEAT BACK COVER
2 – SEAT BACK CUSHION
Fig. 9 Hog Ring
1 – SEAT BACK CUSHION
2 – HOG RING
3 – SUPPORT
Fig. 10 Hook And Loop Fastener
1 – SEAT BACK COVER
2 – HOOK AND LOOP FASTENER
3 – SEAT BACK CUSHION
23 - 16
BODY
XJ
REMOVAL AND INSTALLATION (Continued)