Jeep Cherokee 2000 Service Manual - page 463
(2) Depress the opposite terminal inward and
engage the remaining bulb wire loop.
(3) Position the lamp lens on the lamp base and
press into place.
CARGO LAMP BULB
REMOVAL
(1) Insert a small flat blade into the access slots
(Fig. 9).
(2) Carefully pry the lens from the lamp.
(3) Grasp bulb and pull from lamp.
INSTALLATION
(1) Position bulb in lamp and snap into place.
(2) Position the lens at the lamp housing and force
it upward into the housing until the mounting tabs
are seated on the lamp mounting pins.
MAP READING LAMP BULB
REMOVAL
(1) Insert a flat blade screwdriver in slot at front
of lens (Fig. 10).
(2) Rotate the screwdriver until lens snaps out of
the housing.
(3) Remove lens from housing.
(4) Remove bulb from terminals.
INSTALLATION
(1) Insert bulb into reading lamp terminals.
(2) Replace lens by holding lens level and pushing
rearward into housing.
(3) Push lens up to snap into housing.
VISOR VANITY LAMP BULB
REMOVAL
(1) Using a small flat blade, carefully pry each cor-
ner of lens outward from lamp.
(2) Separate lens from lamp.
(3) Grasp bulb and pull outward.
INSTALLATION
(1) Position bulb in socket and push into place.
(2) Position lens on lamp and snap into place.
Fig. 9 Cargo Lamp Lens
1 – HOUSING
2 – SCREWDRIVER SLOTS
3 – CARGO LAMP
4 – LENS
Fig. 10 Reading Lamp Bulb
1 – LENS
2 – FLAT BLADE
3 – CONSOLE
XJ
LAMPS
8L - 13
REMOVAL AND INSTALLATION (Continued)