Jeep Cherokee 2000 Service Manual - page 1568
INSTALLATION
(1) Lubricate and install new seal on cable.
(2) Insert cable in transmission case.
(3) Attach cable to throttle cam (Fig. 92).
(4) Install cable bracket on case and tighten
attaching bolt to 10 N·m (7 ft. lbs.) torque (Fig. 93).
(5) Install pan and tighten pan bolts to 7 N·m (65
in. lbs.) torque.
(6) Install new gasket on oil pan drain plug.
Install and tighten plug to 20 N·m (15 ft. lbs.) torque.
(7) Connect cable to engine bracket and throttle
linkage.
(8) Fill transmission with Mopar
t
Dexron/Mercon
IIE.
(9) Adjust the cable as described in cable adjust-
ment procedure.
OIL PUMP SEAL
REMOVAL
(1) Remove converter.
(2) Remove old seal. Use blunt punch to collapse
seal and pry seal out of pump housing. Do not
scratch or damage seal bore.
INSTALLATION
(1) Lubricate lip of new seal with transmission
fluid and install seal in pump with tool 7549 (Fig.
94).
(2) Lubricate converter drive hub with transmis-
sion fluid.
(3) Align and install converter in oil pump.
Fig. 92 Removing/Installing Transmission Throttle
Cable
1 – THROTTLE CABLE
2 – CABLE BRACKET
Fig. 93 Removing/Installing Transmission Throttle
Cable And Bracket
1 – THROTTLE CABLE
2 – CABLE BRACKET
Fig. 94 Installing Oil Pump Seal
1 – PUMP SEALER INSTALLER
21 - 268
AW–4 AUTOMATIC TRANSMISSION
XJ
REMOVAL AND INSTALLATION (Continued)