Jeep Cherokee 2000 Service Manual - page 542
REMOVAL AND INSTALLATION
POWER SEAT SWITCH
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the three screws that secure the seat
cushion side shield to the outboard seat cushion
frame.
(3) Pull the seat cushion side shield away from the
seat cushion frame far enough to access the power
seat switch wire harness connector.
(4) Unplug the wire harness connector from the
power seat switch.
(5) Remove the seat cushion side shield from the
seat.
(6) Remove the two screws that secure the power
seat switch to the inside of the seat cushion side
shield (Fig. 2).
(7) Remove the power seat switch from the seat
cushion side shield.
(8) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
POWER SEAT ADJUSTER AND MOTORS
(1) Move the seat to its fully raised and fully for-
ward position, if possible.
(2) Disconnect and isolate the battery negative
cable.
(3) For the driver side power seaat only, unplug
the seat belt switch wire harness connector from the
driver side seat belt buckle half on the inboard side
of the seat (Fig. 3).
(4) Unplug the power seat wire harness connector
from the body wire harness connector.
Fig. 1 Power Seat Switch Continuity
POWER SEAT SWITCH
LEFT SEAT SWITCH
SWITCH POSITION
CONTINUITY BETWEEN
Off
B-E, B-J, B-K, B-L,
B-M, B-N
Vertical Up
A-J, A-M, B-E, B-N
Vertical Down
A-E, A-N, B-J, B-M
Horizontal Forward
A-L, B-K
Horizontal Rearward
A-K, B-L
Front Tilt Up
A-M, B-N
Front Tilt Down
A-N, B-M
Rear Tilt Up
A-J, B-E
Rear Tilt Down
A-E, B-J
RIGHT SEAT SWITCH
SWITCH POSITION
CONTINUITY BETWEEN
Off
A-E, A-J, A-K, A-L,
A-M, A-N
Vertical Up
A-J, A-N, B-E, B-M
Vertical Down
A-E, A-M, B-J, B-N
Horizontal Forward
A-L, B-K
Horizontal Rearward
A-K, B-L
Front Tilt Up
A-N, B-M
Front Tilt Down
A-M, B-N
Rear Tilt Up
A-J, B-E
Rear Tilt Down
A-E, B-J
Fig. 2 Power Seat Switch Remove/Install
1 – SEAT SIDE SHIELD
2 – POWER SEAT SWITCH
3 – SCREWS
XJ
POWER SEAT SYSTEMS
8R - 3
DIAGNOSIS AND TESTING (Continued)