Jeep Cherokee 2000 Service Manual - page 1167
(4) Install the rivet attaching the end cap to air
deflector.
FRONT BUMPER
REMOVAL
(1) Remove bumper end caps.
(2) If equipped, disengage fog lamp wire harness
connectors.
(3) Disconnect vacuum line from reservoir (Fig. 3).
(4) Remove Torx-head bolts that attach bumper to
mounting brackets (Fig. 1).
(5) Remove bumper from vehicle.
(6) If necessary, remove bolts attaching bumper
mounting brackets to frame.
INSTALLATION
(1) If removed, install bolts attaching bumper
mounting brackets to frame. Tighten bolts to 55 N·m
(41 ft. lbs.) torque.
(2) Position bumper on front of vehicle.
(3) Install Torx-head bolts that attach bumper to
mounting brackets. Tighten bolts to 55 N·m (41 ft.
lbs.) torque.
(4) Connect vacuum line to reservoir.
(5) If equipped, engage fog lamp wire harness con-
nectors.
(6) Install bumper end caps.
FRONT TOW HOOK
REMOVAL
(1) Remove bolts attaching tow hook to tow hook
reinforcement (Fig. 4).
(2) Separate tow hook from reinforcement.
(3) If necessary, remove bolt attaching tow hook
reinforcement to frame.
INSTALLATION
(1) If removed, install bolt attaching tow hook
reinforcement to frame. Tighten bolt to 30 N·m (22 ft.
lbs.) torque.
(2) Position tow hook on reinforcement.
(3) Install bolts attaching tow hook to tow hook
reinforcement. Tighten bolts to 100 N·m (74 ft. lbs.)
torque.
Fig. 2 Bumper End Cap
1 – RETAINER TAB
2 – BUMPER END CAP
3 – BUMPER
4 – GRILLE
Fig. 3 Vacuum Reservoir
1 – VACUUM LINE
2 – RESERVOIR SCREWS
3 – VACUUM RESERVOIR
Fig. 4 Front Tow Hook
1 – MOUNTING BRACKET
2 – TOW HOOK
3 – TOW HOOK REINFORCEMENT
XJ
FRAME AND BUMPERS
13 - 3
REMOVAL AND INSTALLATION (Continued)