Jeep Cherokee 2000 Service Manual - page 344
INSTALLATION
(1) Position generator to engine and snap field
wire connector into rear of generator.
(2) Install B+ terminal to generator mounting
stud. Tighten mounting nut to 8.5 N·m (75 in. lbs.)
torque.
(3) If equipped, snap plastic cover to B+ terminal.
(4) LHD Vehicles: Install generator fasteners and
tighten as follows:
•
Generator upper mounting bolt-55 N·m (41 ft.
lbs.) torque.
•
Generator lower pivot bolt/nut-55 N·m (41 ft.
lbs.) torque.
CAUTION: Never force a belt over a pulley rim
using a screwdriver. The synthetic fiber of the belt
can be damaged.
CAUTION: When installing a serpentine accessory
drive belt, the belt MUST be routed correctly. The
water pump will be rotating in the wrong direction if
the belt is installed incorrectly, causing the engine
to overheat. Refer to belt routing label in engine
compartment, or refer to Belt Schematics in Group
7, Cooling System.
(5) LHD Vehicles: Install generator drive belt.
Refer to Group 7, Cooling System for procedures.
(6) RHD Vehicles: Install upper nut (generator
adjustment nut) and both belt adjustment bolts.
Install generator lower nut/bolt.
(7) RHD Vehicles: On vehicles equipped with RHD,
the generator is used to adjust the serpentine belt.
Refer to Group 7, Cooling System for belt routing,
belt adjustment and bolt tightening procedures.
(8) Install negative battery cable to battery.
Fig. 2 Remove/Install Generator—4.0L Engine—LHD
1 – UPPER MOUNTING BRACKET
2 – GENERATOR
3 – UPPER BOLT
4 – LOWER BOLT
Fig. 3 Remove/Install Generator—4.0L Engine—RHD
1 – UPPER NUT
2 – LOWER BOLT
3 – GENERATOR
4 – BELT ADJUSTMENT BOLTS
Fig. 4 Generator Connectors—Typical Denso
1 – FIELD WIRES
2 – B+ (OUTPUT TERMINAL)
3 – FIELD WIRE CONNECTOR
8C - 4
CHARGING SYSTEM
XJ
REMOVAL AND INSTALLATION (Continued)