Jeep Cherokee 2000 Service Manual - Starting Systems
STARTING SYSTEMS
TABLE OF CONTENTS
page
page
REMOVAL AND INSTALLATION
STARTER — LHD (DIESEL) . . . . . . . . . . . . . . . . . 1
STARTER — RHD (DIESEL). . . . . . . . . . . . . . . . . 2
STARTER RELAY . . . . . . . . . . . . . . . . . . . . . . . . . 3
SPECIFICATIONS
STARTING SYSTEM . . . . . . . . . . . . . . . . . . . . . . . 3
TORQUE SPECIFICATIONS . . . . . . . . . . . . . . . . . . 4
REMOVAL AND INSTALLATION
STARTER — LHD (DIESEL)
Removal
(1) Disconnect the negative battery cable.
(2) Remove the innercooler inlet hose from turbo-
charger and position it out of the way (Fig. 1).
(3) Remove the (2) right engine mount upper sill
plate nuts.
(4) Raise the vehicle on a hoist.
(5) Remove the turbocharger oil return hose from
engine block and plug (Fig. 2).
(6) Remove the right engine mount through bolt
nut only (Fig. 2). Do not remove the bolt at this time.
(7) Position a jack stand and raise the weight off
the right engine mount.
(8) Remove the (2) right engine mount lower sill
plate bolts.
(9) Remove the (4) right engine mount bracket to
engine block retaining bolts.
(10) Remove the engine mount throughbolt.
(11) Remove the engine mount and the engine
mount bracket from the vehicle.
Fig. 1 LHD Engine Compartment — Diesel
1 – INTAKE MANIFOLD ELBOW
2 – BREATHER HOSE
3 – INNERCOOLER OUTLET HOSE
4 – AIR FILTER COVER
5 – AIR FILTER OUTLET (FRESH AIR) HOSE
6 – INNERCOOLER INLET HOSE
7 – HEATER CORE COOLANT SUPPLY HOSES
Fig. 2 Turbocharger Oil Return Hose — Position &
Orientation
1 – VEHICLE UNDERBODY
2 – RIGHT ENGINE MOUNT THROUGHBOLT NUT
3 – TURBOCHARGER OIL RETURN HOSE
4 – EXHAUST MANIFOLD DOWNPIPE
5 – TURBOCHARGER
XJ
STARTING SYSTEMS
8B - 1