Jeep Cherokee 2000 Service Manual - Lamp Bulb Service
LAMP BULB SERVICE
TABLE OF CONTENTS
page
page
REMOVAL AND INSTALLATION
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 10
FOG LAMP BULB. . . . . . . . . . . . . . . . . . . . . . . . . 10
FRONT PARK/TURN SIGNAL LAMP BULB . . . . . . 11
SIDE MARKER LAMP BULB . . . . . . . . . . . . . . . . . 11
BACK-UP/BRAKE/REAR TURN SIGNAL/TAIL
LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
LICENSE PLATE LAMP BULB . . . . . . . . . . . . . . . 12
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB . . . . . . . . . . . . . . . . . . . . . . . . . 12
UNDERHOOD LAMP BULB . . . . . . . . . . . . . . . . . 12
CARGO LAMP BULB . . . . . . . . . . . . . . . . . . . . . . 13
MAP READING LAMP BULB. . . . . . . . . . . . . . . . . 13
VISOR VANITY LAMP BULB. . . . . . . . . . . . . . . . . 13
REMOVAL AND INSTALLATION
HEADLAMP BULB
REMOVAL
(1) Remove the screws attaching the bezel to the
grille opening panel (Fig. 1).
(2) Remove screws attaching the retaining ring to
the headlamp canister.
(3) Disconnect the headlamp bulb wire harness
connector.
(4) Separate the sealed beam from the vehicle.
INSTALLATION
(1) Connect wire harness connector.
(2) Position bulb in canister.
(3) Position retaining ring on sealed beam and
install screws.
(4) Install headlamp bezel.
FOG LAMP BULB
REMOVAL
(1) Remove the screws attaching the access cover
to the bottom of the fog lamp (Fig. 2).
(2) Remove spring clip securing bulb to fog lamp.
(3) Disconnect bulb wire connector.
(4) Remove bulb element from fog lamp.
INSTALLATION
CAUTION: Do not touch the bulb glass with fingers
or other oily surfaces. Reduced bulb life will result.
(1) Position bulb element in fog lamp.
Fig. 1 Headlamp Bezel
1 – HEADLAMP ADJUSTMENT
2 – NUT
3 – HEADLAMP
4 – BEZEL
5 – PARK/TURN LAMP
6 – SPRING
7 – BUMPER
Fig. 2 Fog Lamp Components
1 – FOG LAMP
2 – CLIP
3 – BULB
4 – ACCESS COVER
5 – BULB SOCKET
8L - 10
LAMPS
XJ